GLOCK BARREL G20 10MM

$150.95

Genuine OEM Glock replacement barrel. Barrel rifling has hexagonal profile with right hand twist. 4.60 inch – 117mm length. Fits M/20. Part number 15 on the Glock Schematic.

Category:

glock g20 barrel Genuine OEM Glock replacement barrel. Barrel rifling has hexagonal profile with right hand twist. 4.60 inch – 117mm length. Fits M/20. Part number 15 on the Glock Schematic. glock g20 barrel

10mm glock barrel

The GLOCK 20 SF combines the SF (Short Frame) design with the powerful 10 mm Auto AUTO cartridge. making the frame more comfortable and significantly enhancing controllability and accuracy. The SF design reduces the circumference of the receiver at the rear offering increased ease-of-use and control.

especially to shooters with smaller hands. The GLOCK 20 SF dimensions also provide a long sight radius for better precision.

Our advanced proprietary button rifling process allows glock barrels to offer greater accuracy over stock barrels. Our Glock barrels come with fully supported SAAMI spec match chambers for shooting factory or reloaded ammunition as well as lead or jacketed bullets. Unless noted all barrels are drop-in fit.

Genuine OEM Glock replacement barrel. Barrel rifling has hexagonal profile with right hand twist. 4.60 inch – 117mm length. Fits M/20. Part number 15 on the Glock Schematic.

Our advanced proprietary button rifling process allows KKM barrels to offer greater accuracy over stock barrels. Our Glock barrels come with fully supported SAAMI spec match chambers for shooting factory or reloaded ammunition as well as lead or jacketed bullets. Unless noted all barrels are drop-in fit.

GLOCK BARRELS AND HOW TO CHOSE ONE

 

The challenge then becomes determining which of the dozen-or-so options is the best barrel for the money.  We’ve tried several different Glock barrels and had four on hand for our Glock 19.  When we received the barrel from L2D Combat it was immediately noticeable that the quality was a bit different.  This was not a foreign-made wad of metal, but rather steel crafted with the intent of making something better.

Made of 416R steel with a  crowned muzzle and lapped rifling, the L2D Combat barrel has more in common with a precision rifle barrel than a handgun barrel.  To truly show the differences the video below was created.

How to Replace Your Glock Barrel

 

First, the obvious.  When installing your replacement barrel in your Glock, take safety seriously.

1. Ensure there is no magazine in the gun and pull the slide to the rear to visually inspect the chamber.

2. Hey you! DO NOT simply rack the action and rely on the extractor to remove a cartridge from the chamber. I did that once with a .22 when I was 12 and shot my Dad’s suburban.  Not as cool as it sounds.

3. On that note, point the gun in a safe direction at all times, but especially when you dry fire it.

4. Once you have visually inspected the gun, make a final check that there is no ammunition in the area where you are working.

Ok…replacing a barrel is the easiest of all Glock mods out there. It can be done in less than a minute once you understand a few basic steps.

STEPS :

Step 1– Remove the magazine and clear the pistol. Finish by dry firing the pistol in a safe direction  The trigger must be to the rear for this process to work.

Step 2– Use one hand to withdraw the slide approximately 1/8thof an inch.  Not too much! If you pull the slide back enough to reset the trigger (about ½”), the slide will not come off.

Step 3– With your other hand, pinch the slide lock (take down) and simultaneously pull down hard on both sides and hold.

Step 4– Allow the entire slide assembly to come forward off the frame rails.

 

Reviews

There are no reviews yet.

Be the first to review “GLOCK BARREL G20 10MM”

Your email address will not be published. Required fields are marked *

Shopping Cart